E 300 Operator Interface
M&R Printing Equipment, Inc. - Glen Ellyn, Illinois
47
the word “Revolver” in “Revolver Mode”.
To activate the revolver mode simply press the
“ENTER” key one time. The “ON/OFF” indication
will now change to “ON”. (See Figure 7 above)
Pressing the “ENTER” key once again will change
the indication to “OFF”. Press the “ARROW DOWN”
key one time, then press the “ARROW RIGHT” key.
The flashing cursor is now located under the letter
“I” in the word “INDEX”. Press the “ENTER” key
one time. You will be presented with a “WAIT” indi-
cation, after which the current index dwell time as
programmed under the “TIMERS” menu will be acti-
vated. The “INDEX DELAY” L.E.D. will display a red
indication when the timer is inactive and a green
indication when the “INDEX DELAY” is activated.
Press the “ARROW DOWN” key one time, then
press the “ARROW RIGHT” key one time to access
the “Stop Alarm” menu item. When the flashing cur-
sor is located under the letter “S” in the word
“STOP”, press the “ENTER” key one time.
You will see the “WAIT” message appear in the mes-
sage window. This control feature allows the system
Operator to over-ride the audible alarm signal which
indicates the approaching end of a programmed
print sequence in the Revolver mode of operation.
(See Figure 7 above)
Press the “ARROW DOWN” key one time, then
press the “ARROW RIGHT” key one time to access
the “Enter Program” menu item. This control func-
tion is used to enter print sequences for the Revolver
program mode of operation. When the flashing cur-
sor is located under the letter “E” in the word
“ENTER”, press the “ENTER” key one time. You will
see the “WAIT” message appear in the message
window, after which your pre-selected program
information will be saved in the PLC memory.
The next menu item is “Revolution No.” Press the
“ARROW DOWN” key one time, then press the
“ARROW RIGHT” key one time.
Figure 7
>Revolver Mode: On
>Index Delay: Off
>Stop Alarm
>Enter Program
Revolution No. : 1
181716151413121110 9 8 7 6 5 4 3 2 1
To Next Page
Loading...
