Manitou 150 AETJ - Brakes

CHECK Brakes
BRAKING DISTANCE ON A LEVEL SURFACE
NOTE: The platform is switched on. The platform is in transport position. The turntable, the basket and the jib (150AETJ3D
(150AETJC3D)) are in neutral position. The jib is completely lowered.
NOTE: The turntable cover is removed.
- Select a level surface for the following test.
- Place a uniformly distributed load in the basket = 200 kg less your own weight.
- Get into the basket.
- Drive the platform forward until the maximum speed is reached.
- Release the control handle to brake the platform.
Result:
• The braking distance should be: 1000mm ±200mm.
- Raise the jib for 2seconds and extend the telescope for 2seconds.
- Drive the platform forward until the maximum speed is reached:
NOTE: The driving speed must be WORKING POSITION speed.
- Release the control handle to brake the platform.
Result:
• The braking distance should be: 70mm ±30mm.
- Fully retract the telescope and lower the jib completely.
BRAKING ON A SLOPE
NOTE: The platform is switched on. The platform is in transport position.
The turntable, the basket and the jib (150AETJ3D (150AETJC3D))
are in neutral position. The jib is completely lowered. The previous
test load is in the basket.
NOTE: The turntable cover is removed.
- Select a slope of 20% (11.3°) for the following test.
- Raise the jib to the horizontal position.
- Drive the platform forwards slowly on the slope, facing it, with the basket at the bottom of the slope.
- Release the control handle to brake the platform on the slope.
Result:
• The platform should be immobilized on the slope for at least 1minute.
- Drive the platform off the slope.
- Lower the jib completely.
- Get out of the basket.
- Remove the load from the basket.
3 - 34
647536 (26/11/2020) 150 AETJ/AETJ 3D - 150 AETJ C/AETJ C 3D - 170 AETJ L