EasyManua.ls Logo

Manitou 150 AETJ - Clean; REPLACE Hydraulic Oil; REPLACE Hydraulic Return Filter Cartridge; Suction Strainer

Manitou 150 AETJ
134 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
REPLACE Hydraulic oil
REPLACE Hydraulic return filter cartridge
CLEAN Suction strainer
t
IMPORTANT
t
It is recommended that the oil is slightly warm before being changed.
Clean the oil can before adding oil to the hydraulic oil tank.
Use a clean funnel to add oil to the hydraulic oil tank.
NOTE: The left turntable cover is open.
FIRST VERSION
DRAIN THE OIL
- Clean the outside of the tank
1
with a clean cloth.
- Clean the outside of the hydrostatic return filter assembly
2
with a clean cloth.
- Locate the drain plug
3
and put a drain pan underneath.
- Remove the drain plug and the tank plug
4
.
- Wait until the tank is completely empty.
REPLACE THE HYDRAULIC RETURN FILTER CARTRIDGE
6
- Remove the cover of the hydraulic return filter
5
.
- Remove the used hydraulic return filter cartridge.
- Put the new hydraulic return filter cartridge in place, eFILTER CARTRIDGES.
- Put the hydraulic return filter cover back in place.
CLEAN THE SUCTION STRAINER
- Locate the hydraulic hose
7
and put a drain pan underneath.
- Remove the hydraulic hose, the union fitting and the suction strainer
8
.
- Clean the suction strainer with compressed air, from the inside out:
• Maximum pressure = 3 bars. Minimum distance = 30 mm.
- Check its condition. Replace it if necessary, eFILTER CARTRIDGES.
- Refit the suction strainer, the union fitting and the hydraulic hose.
FILL THE HYDRAULIC OIL TANK
- Refit the drain plug
3
.
- Fill the tank with new hydraulic oil, eLUBRICANTS. The level is correct when the
oil reaches the red dot on the level indicator
9
.
- Refit the tank cap
4
.
- Switch the platform on. Activate the functions for 10 minutes.
- Check for leaks.
- Place the platform in transport position. Put the turntable, the basket and the jib
(150AETJ3D (150AETJC3D)) in neutral position. Lower the jib completely.
- Check the hydraulic oil level. Top up if necessary.
- Close the left-hand turntable cover.
- Turn the platform off.
3 - 40
5
6
7
8
3
1
2
4
9
647536 (26/11/2020)
150 AETJ/AETJ 3D - 150 AETJ C/AETJ C 3D - 170 AETJ L

Table of Contents

Related product manuals