Manitou 150 AETJ - GREASE Crown Gear Bearings; LUBRICATE Telescope

LUBRICATE Telescope
t
IMPORTANT
t
Lubricate the telescope more often when the platform is used in a dusty environment.
NOTE: The turntable cover is removed.
- Switch the platform on.
- Raise the jib slightly.
- Fully extend the telescope.
- Check the sliding surfaces
A
of the pads:
• Surfaces must be smooth and free from corrosion.
- Lubricate the telescope if necessary, eLUBRICANTS.
NOTE: Extend and retract the telescope several times to spread the lubricant. Remove
the excess with a clean cloth.
- Fully retract the telescope.
- Lower the jib completely.
- Turn the platform off.
GREASE Crown gear bearings
NOTE: The turntable cover is removed.
- Remove the 2 caps of the lubrication connectors
1
for the crown gear.
- Inject the lubricant into the lubrication connectors, eLUBRICANTS.
- Switch the platform on.
- Turn the turntable 90° to the left or the right and inject lubricant again.
- Refit the lubrication connector caps.
- Turn the turntable a full turn to spread the lubricant.
- Put the turntable in neutral position.
- Put the turntable cover
2
back in place.
- Turn the platform off.
RESET Maintenance warning
e50H-PERIODIC MAINTENANCE - EVERY 50 HOURS OF SERVICE OR 3 MONTHS.
3 - 36
A
A
1
2
647536 (26/11/2020) 150 AETJ/AETJ 3D - 150 AETJ C/AETJ C 3D - 170 AETJ L