Manitou MI-X 50L D C ST3A S2 - Drivers Seat

1 - DRIVER'S SEAT
DESIGNED FOR MAXIMUM COMFORT, THIS SEAT CAN BE ADJUSTED AS FOLLOWS.
WEIGHT ADJUSTMENT (FIG. A)
Adjust the weight when the driver is sitting on the seat.
- Switch on lift truck ignition.
- Move the switch 1 up to increase the weight or down to reduce it.
- The driver's weight is correctly adjusted when the marker is in the centre of indicator 2.
NOTE: To avoid any health problems, it is recommended that the weight should be
checked and adjusted before using the lift truck.
LONGITUDINAL ADJUSTMENT (FIG. B)
- Adjust the locking lever until you reach the position required. This then locks and
the seat will not shift into another position.

IMPORTANT

Only operate the lever by its recessed section and do not grasp from below, at the risk of crushing the hand.
LUMBAR ADJUSTMENT (FIG. C)
This increases the comfort of the seat and the driver’s freedom of movement.
-T
urn knob to 1 to adjust the height and depth of the lumbar support of the upper
part of the back-rest.
-T
urn knob to 2 to adjust the height and depth of the lumbar support of the lower
part of the back-rest.
ANGLE ADJUSTMENT OF THE BACK-REST (FIG. D)
- Support the back-rest, pull the lever and position the back-rest to find the desired
position.

IMPORTANT

If you do not support the back rest when making adjustments, it will tilt forwards.
MAINTENANCE
Dirt may adversely affect the correct functioning of the seat. For this reason, make sure
your seat is always clean.
- The cushions do not require to be removed from the seat frame for cleaning.

IMPORTANT

A moving backrest increases the risk of an accident!
First check the resistance of the fabric on a small concealed area before using any fabric
and plastic cleaner.
2-22
C
D
B
A
2
1
647650 (19/02/2018)
M
I-X 50L/60/70 D C ST3A S2 / MI 50L/60/70 D ST3B S2 / MI 50L/60/70 G S2