Manitou MI-X 50L D C ST3A S2 - Page 74


IMPORTANT

USE THE RECOMMENDED LUBRICANTS AND FUEL:
- For topping up, oils may not be miscible.
- For oil changes, MANITOU oils are perfectly appropriate.
DIAGNOSTIC ANALYSIS OF OILS
If a service or maintenance contract has been organised with the dealer, a diagnostic analysis of engine, transmission and
axle oils may be requested depending on the rate of use.
(*) REQUIRED FUEL SPECIFICATION
Use a high-quality fuel to obtain optimal performance of the engine.
• EN590 diesel fuel (sulphur content < 10 ppm)
• ASTM D975 diesel fuel (sulphur content < 15 ppm)
RECOMMENDATION
ENGINE
PARTS TO BE LUBRICATED CAPACITY RECOMMENDATION
-40 °C -30 -20 -10 0 +10 +20 +30 +40 +50 °C
0W30
0W40
5W30
5W40
10W30
ENGINE
MANITOU EVOLOGY OIL 10W40 API CJ4
MI-X . . D C ST3A S2 8 Litres
MI . . D ST3B S2 9 Litres
MI . . G S2 4.25 Litres
15W40
20W50
-40 °C -30 -20 -10 0 +10 +20 +30 +40 +50 °C
COOLING CIRCUIT
MI 50L / 60 / 70 ...
MI 80 / 100 ...
23 Litres
28 Litres
COOLANT -35°C
-40°C -30 -20 -10 0 +10 +20 +30 +40 +50°C
FUEL TANK
MI 50L / 60 / 70 D
MI 80 / 100 D
110 Litres
120 Litres
GNR HP DIESEL *
-40°C -30 -20 -10 0 +10 +20 +30 +40 +50°C
GAS CYLINDER
MI ... G
13 kg Propane LPG
MAST
PARTS TO BE LUBRICATED RECOMMENDATION
-40°C -30 -20 -10 0 +10 +20 +30 +40 +50°C
MAST LIFTING CHAINS MANITOU SPECIAL CHAIN LUBRICANT (aerosol)
-40°C -30 -20 -10 0 +10 +20 +30 +40 +50°C
GREASING OF THE MAST MANITOU BLACK MULTI-PURPOSE LUBRICANT
HYDRAULICS
PARTS TO BE LUBRICATED CAPACITY RECOMMENDATION
-40°C -30 -20 -10 0 +10 +20 +30 +40 +50°C
ISO VG 100
ISO VG 68
HYDRAULIC OIL TANK ISO VG 46
ISO VG 37
110 Litres
MANITOU ISO VG 32 HYDRAULIC OIL
LUBRICANTS AND FUEL
3 - 12
647650 (19/02/2018)
M
I-X 50L/60/70 D C ST3A S2 / MI 50L/60/70 D ST3B S2 / MI 50L/60/70 G S2