Manitou MI-X 50L D C ST3A S2 - Page 77

MI . . D ST3B S2
- Pull out and clean the dipstick 1.
- Reinsert the dipstick and remove it again.
- Check the correct level between the two notches.
- If necessary, add oil ( LUBRICANTS AND FUEL).
- Unscrew the thumbscrews 2 and remove the housing 3.
- Remove the cover 4 to access filler cap 5.
- Add oil through filler port 6.
- Visually check that there is no leakage or seepage of oil in the engine.
MI . . G S2
- Pull out and clean the dipstick 1.
- Reinsert the dipstick and remove it again.
- Check the correct level between the two notches.
- If necessary, add oil ( LUBRICANTS AND FUEL) through the filler port 2.
- Visually check that there is no leakage or seepage of oil in the engine.
3 - 15
1
2
1
2
2
3
4
6
5
647650 (19/02/2018)
M
I-X 50L/60/70 D C ST3A S2 / MI 50L/60/70 D ST3B S2 / MI 50L/60/70 G S2