Manitou MLT 845 120 LSU 3-E3 Series User Manual

3-303-30

E10 - SEAT BELT
E10 - SEAT BELT
CHECKCHECK
Seat belt with two anchoring pointsSeat belt with two anchoring points
- Check the following points:- Check the following points:
• Fixing of the anchoring points • Fixing of the anchoring points on the seat.on the seat.
• Cleanness of the strap and the locking • Cleanness of the strap and the locking mechanism.mechanism.
• Triggering of the locking mechanism.• Triggering of the locking mechanism.
• Condition of the strap (cuts, curled edges).• Condition of the strap (cuts, curled edges).
Reeled seat belt with two anchoring pointsReeled seat belt with two anchoring points
- Check the points listed above together - Check the points listed above together with the following points:with the following points:
• The correct winding of the belt.• The correct winding of the belt.
• Condition of the reel guards.• Condition of the reel guards.
• Roller locking mechanism when the strap is given a sharp tug.• Roller locking mechanism when the strap is given a sharp tug.
NOTE: After an accident, replace the seat NOTE: After an accident, replace the seat belt.belt.
In no event should the lift In no event should the lift truck be used if the seat truck be used if the seat belt is defective (fixing, locking, cuts, tears, etc.). Repair or replace the seat belt immediately.belt is defective (fixing, locking, cuts, tears, etc.). Repair or replace the seat belt immediately.
E11 - FRONT AND REAR WHEELS REDUCERS OILE11 - FRONT AND REAR WHEELS REDUCERS OIL
DRAINDRAIN
Place the lift truck on level ground with the I.C. engine stopped and the reducers oil stillPlace the lift truck on level ground with the I.C. engine stopped and the reducers oil still
warm.warm.
Dispose of the drain oil in Dispose of the drain oil in an ecological manneran ecological manner..
- Drain and change each front - Drain and change each front wheel reducer.wheel reducer.
- Place drain plug 1 (fig. E11) in position A.- Place drain plug 1 (fig. E11) in position A.
- Place a container under the drain plug and unscrew the plug.- Place a container under the drain plug and unscrew the plug.
- Let the oil drain - Let the oil drain fully.fully.
- Place the drain port in position B, i.e. in a level port.- Place the drain port in position B, i.e. in a level port.
-- Fill up with oil (see: 3 - Fill up with oil (see: 3 - MAINTENANCE: LUBRICANTS AND MAINTENANCE: LUBRICANTS AND FUEL) by level port 1 (fig.FUEL) by level port 1 (fig.
E11).E11).
- The level is correct when the oil level is flush with the edge of the hole.- The level is correct when the oil level is flush with the edge of the hole.
- Refit and tighten the drain plug 1 (fig. E11) (tightening torque 34 to 49 N.m).- Refit and tighten the drain plug 1 (fig. E11) (tightening torque 34 to 49 N.m).
- Repeat this operation on each rear - Repeat this operation on each rear wheel reducer.wheel reducer.
E11E11
AA
BB
11
https://www.forkliftpdfmanuals.com/

Manitou MLT 845 120 LSU 3-E3 Series Specifications

General

Brand	Manitou
Model	MLT 845 120 LSU 3-E3 Series
Category	Forklifts
Language	English