F2 - AIR CONDITIONING (OPTION)
F2 - AIR CONDITIONING (OPTION)
CLEANING – INSPECTIONCLEANING – INSPECTION
CLEANING CONDENSER AND EVAPORATOR COILS (*)CLEANING CONDENSER AND EVAPORATOR COILS (*)
CLEANING CONDENSATE TRAY AND RELIEF VALVE (*)CLEANING CONDENSATE TRAY AND RELIEF VALVE (*)
COLLECTING COOLANT TO REPLACE FILTER-DRIER (*)COLLECTING COOLANT TO REPLACE FILTER-DRIER (*)
REFILLING WITH COOLANT AND CHECKING THE THERMOSTATIC CONTROL AND PRESSURE SWITCHES (*)REFILLING WITH COOLANT AND CHECKING THE THERMOSTATIC CONTROL AND PRESSURE SWITCHES (*)
NOTE: When opening the evaporator unit, rNOTE: When opening the evaporator unit, remember to replace the cover seal.emember to replace the cover seal.
(*): (CONSULT YOUR DEALER).(*): (CONSULT YOUR DEALER).
CAUTION: DO NOT CAUTION: DO NOT ATTATTEMPT TO REPAIR ANY PROBLEMS EMPT TO REPAIR ANY PROBLEMS YOURSELFYOURSELF. ALWA. ALWAYS REFER TO YS REFER TO YOUR DEALER WHEN YOUR DEALER WHEN REFILLING CIRCUITS, AS THEY HOLD REFILLING CIRCUITS, AS THEY HOLD THETHE
CORRECT SPARE PARTS, AS WELL AS HAVING THE NECESSARY TECHNICAL KNOWLEDGE AND TOOLS.CORRECT SPARE PARTS, AS WELL AS HAVING THE NECESSARY TECHNICAL KNOWLEDGE AND TOOLS.
- Do not open the circuit under any circumstances as this would cause the coolant to be lost.- Do not open the circuit under any circumstances as this would cause the coolant to be lost.
-- The cooling circuit contains a gas which caThe cooling circuit contains a gas which can be dangerous under certain conditions. This gas, coolant R n be dangerous under certain conditions. This gas, coolant R 134a, is colourless,134a, is colourless,
odourless and heavier than air.odourless and heavier than air.
• If this gas is • If this gas is inhaled, take the victim into fresh air, give oxygen or arinhaled, take the victim into fresh air, give oxygen or artificial respiration if necessary and call a tificial respiration if necessary and call a doctordoctor..
• If the gas is • If the gas is in contact with the skin, wash it in contact with the skin, wash it immediately under running water and remove any contaminated garments.immediately under running water and remove any contaminated garments.
• If the gas is • If the gas is in contact with the eyes, rinse them in in contact with the eyes, rinse them in clear water for 15 minutes and call a clear water for 15 minutes and call a doctordoctor..
-- The compressor has an oil level gauge (fThe compressor has an oil level gauge (fig. F2). Never unscrew this gauge big. F2). Never unscrew this gauge because itecause it
would depressurizes the installation. The oil level is only checked when changing the oilwould depressurizes the installation. The oil level is only checked when changing the oil
in the circuit.in the circuit.
F2F2
To Next Page
Loading...
