3 Replacing appliance parts to rectify problems
Repair Manual C4 72
6.b Gas appliance
PLEASE NOTE:
Risk of damage to the gas supply pipe.
Fix the pipe to one side when taking out the motor.
Fitting the motor
1.
Fit the set of seals onto the motor shaft.
2.
Insert the motor.
Take care not to damage the boiler sensor, and for gas appliances,
the gas supply pipe.
The shaft seal must be able to move easily on the motor shaft.
3. Make sure the motor shaft is positioned centrally in the cooking
chamber when you fit the motor.
4.
Use a degreaser to clean the motor shaft.
There must be absolutely no grease left on the motor shaft and
collet.
To Next Page
Loading...
