EasyManuals Logo

Manitowoc Multiplex Ms-8 User Manual

Manitowoc Multiplex Ms-8
64 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #14 background imageLoading...
Page #14 background image
14 1/12
Clean Blended Ice Machine (BIM-8)(continued)
©McDonald’s Corporation · Planned Maintenance Manual · October 2011 Page 3 of 5
Ble Blended Ice Machine Models MS-8-1H, MS-8-1LH, MS-8-EH, MS-8-ELH, MS-8-BH, MS-8-BLH, MS-8-CH, MS-8-CLH, MS000A03, MS000A04
Weekly BE 23 W1
18
Lube each product line.
Use either Taylor Lube HP or
Carpigiani Carpilube. Put a
small amount of lube around
each product line.
19
Pull the bottom drain pan from
inside the machine.
20
Reconnect product bins and
bags.
Retrieve product bags from
walk-in cooler. Install product
bags into the product bins.
Position the rear groove of the
spout on the product bag into
the front slot of the product
bin. Make sure it’s properly
snapped into place. Then
install each product bin into
its proper location.
21
Replace black cleaning pitcher
with blending pitcher.
Place discharged product in
trash or back sink.
22
Remove Ice hopper lid.
23
Place black cleaning pitcher
on the pitcher pad.
24
Fill a blend pitcher with
SolidSense APSC.
SolidSense APSC
25
Pour in SolidSense APSC.
Slowly pour the SolidSense
APSC into the ice hopper in a
circular motion, as close to
and as high up the inside
walls as possible, without
splashing solution outside the
unit.
26
Use clean sanitizer-soaked
towel to clean inside of
hopper.
Use caution when wiping near
the shaver blade.
27
Rinse ice hopper with clean
water.
Fill a blend pitcher with clean
water. Slowly pour the clean
water into the ice hopper in a
circular motion, as close to
and as high up the inside
walls as possible, without
splashing outside the unit.
Repeat if needed for a
thorough rinse.
28
Remove black cleaning pitcher
from the pitcher pad, be
careful not to splash any
remaining solution from the
pitcher.
29
Spray interior of ice hopper
with Sanitizer Solution.
Allow to air dry.
Use caution when near the
shaver blade.
KAY 5 Sanitizer
30
Remove parts for cleaning and
sanitizing.
Remove the following items
and take them back to the 3-
compartment sink to wash,
rinse and sanitize:
x Blend pitchers
x Scale overflow tray
x Ice hopper lid
x Syrup rail
x Drip pan
x Splash guard
Do not place parts in “Power
Soaker” or dishwasher.
Chemicals
Sharp Objects/Surfaces
Sharp Objects/Surfaces
continued X

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Manitowoc Multiplex Ms-8 and is the answer not in the manual?

Manitowoc Multiplex Ms-8 Specifications

General IconGeneral
BrandManitowoc
ModelMultiplex Ms-8
CategoryIce Maker
LanguageEnglish

Related product manuals