National Crane Published 03-18-2019 Control # 582-04 3-29
NBT30H-2 OPERATOR MANUAL CONTROLS AND OPERATING PROCEDURES
1. The red STOP button (10, Figure 3-28) must be twisted
and released to turn ON the transmitter.
2. To control the crane, the ON/Horn button (2) must be
pressed to activate the remote. The crane horn will
sound as confirmation that the remote is now active.
3. The crane can now be started by pressing and holding
the Engine Start button (13).
4. The remote can now be used to control the crane. To
activate a function move lever (26) that corresponds to
the desired movement to activate desired function.
5. When finished with the remote, press the red STOP
button (10). This will shut off the machine.
NOTE: If the remote is left turned ON for more than 60
minutes, the remote will shut itself off.
NOTE: To turn the crane controls back on with the remote
after pressing the red stop button, the remote
control will need to be reactivated by performing
step 1 to step 4
NOTE: The console override key and switch (see
Figure 3-2) must both be OFF to operate the
remote controls. The remote control functions will
be disabled and the remote buzzer will sound if
either console override is activated in remote
mode. The remote transmitter has an override
button (see Figure 3-28) for use when operating
with the wireless remote control.
If any interference is present in the area and the remote does
not function properly, the radio's channel can be changed.
This is done by pressing and holding the ON/Horn button (2)
while momentarily pressing the Frequency Change button
(4).
Once finished using the Crane Remote, the Remote Power
switch should be turned OFF and the Crane Remote Enable
Switch should be turned to the OFF position. The remote
controller can be stored in the truck cab.
Use of rechargeable batteries or standard AA batteries is
acceptable; however, the batteries can not be charged in the
remote itself.
DANGER
Be sure to turn off the remote by pressing the red stop
button to de-activate the controls in order to prevent crane
from functioning if the controller switches are
inadvertently depressed or bumped during storage.
Failure to comply with these instructions may cause death
or serious injury.
To Next Page
Loading...
