PROGRAMMING SECTION MODEL YB8
April 1999/Manning Environmental Inc.
3DJH%
DATE STAMP The samp
ler possesses the ability t o date stamp events that are logged. T his
stamping occurs in 3 instances:
A. When a program is started
B. When <RESET> <RESET> is executed
C. When midnight occurs
The purpose of the date stamp is to allow the operator to know when various events
occur and when the happen. The sampler does not log the date with every sample,
instead when midnight occurs the date is stamped and each subsequent event, until
the next occurrence of midnight, are recorded on that date.
ENTER MENU SELECTION
__ __ 04:30:02
At this prompt input a 2 and press <ENTER>
# OF EVENTS = __ __ __
04:30:02
Shows the operator the number of events recorded. The sampler
holds a total of 512 events. This is a momentary display (3 seconds).
ENTER THE START #
04:30:02
The operator is then prompted to enter the point (event #) at which
they want to begin the display of recorded events. Input the starting
point as a 3 digit number and press <ENTER>
ENTER THE COUNT #
__ __ __ 04:30:02
The user is then prompted to enter the number of events they wish to
view. Input the number of events to be viewed as a 3 digit number
and press <ENTER>. This feature allows the user to view all the
logged events, a section of the logged events (300 to 400 for
example), or a single event.
To Next Page
Loading...