MODEL YB8 PROGRAMMING SECTION
April 1999/Manning Environmental Inc.
3DJH%
ENTER SCROLL SECONDS
__ __ 04:30:02
To set the scroll seconds, enter a 2 digit number representing the
amount of time, in seconds, you wish the display to show a recorded
event before advancing to the next screen. After inputting press
<ENTER>
The sampler displays recorded events in one of two ways:
A. By entering the scroll seconds, the sampler automatically
advances sequentially through the recorded events, showing each
event fo r t he set number of scroll seconds. T his will continue until
the event entered in the COUNT # is displayed. The sampler will
then return to the ENTER SELECTION prompt within *91.
B. The user can also manually review the logged events, although
scroll seconds still have t o be entered. T o manually examine the
logged events press <DISPLAY> once for each event to be
reviewed. I f <DISPLAY> is not pressed, the unit will default and use
the entered scroll time to advance the display.
PUSH THE DISPLAY
KEY FOR NEXT EVENT
This is a momentary display (3 seconds) to remind the user that they
can manually advance t he log review o r t hat t he unit will do it
automatically based on the time set at the scroll seconds prompt.
_ _:_ _:_ _ , E_ _ _ , B_ _
S_ _ _ , _ _, _ _
This display is divided into multiple sections to communicate
information about t he lo gged sample.
1 Line
st
1 section - Time at which the sample was collected.
st
2 section - Headed by a capital "E", indicates the event number.
nd
3 section - Headed by a capital "B" represents the bottle number.
rd
2 Line
nd
1 section - Headed by a capital "S" indicates the sample number.
st
2 section - Trigger Codes - This is a 2 letter code that specifies
nd
what initiated the sample. F or a complete list of codes,
refer to page 11 - TRIGGER CODES.
3 section - The last section signifies result code. T his t ells t he user
rd
whether the sampler was successful or unsuccessful in
collecting a sample and why.
To quit viewing data, simply press <RESET> once. This takes you to
the beginning of the menu selection in the Data Logging menu. The
unit will continue t o show the events either based on the scroll t ime or
by pressing <DISPLAY> until the STOP # is reached. At this point
the unit will return the operator to the ENTER SELECTION prompt.
To Next Page
Loading...