INSTALLATION
OF
WALNUT
CABINET
The optional walnut cabinet may be installed
in
the
following manner.
If you have an optional plug-in decoder, un-plug
it from
the
chassis.
If
you
do
not
have an
optional plug-in decoder, remove
the
cover plate
from
the
bottom
of
the
chassis by removing
the
four screws. Place
the
rear end
of
the
Marantz
unit into
the
front
end of
the
walnut
cabinet
and
slide it into place.
Using
the
four screws supplied with
the
walnut
cabinet, pass each screw through each
of
the
supplied rubber feet and screw them into
the
holes provided.
If
you have an optional plug-in decoder, install
it
at
this time by plugging
it
into
the
Marantz
unit, passing it through
the
walnut cabinet's
cutout.
If
you
do
not
have an optional plug-in decoder,
replace
the
metal plate
in
the
same manner and
tighten with screws.
SERVICE
NOTES
REPAIRS
Only
the
most
competent
and qualified service
technicians should be allowed
to
service
the
Marantz Model
4300
Stereo 2 +Quadradial 4
Re-
ceiver. The Marantz Company and its warranty
station personnel have
the
knowledge and special
equipment needed for
the
repair and calibration
of
this precision instrument.
In
the
event
of
difficulty, write directly
to
the
factory (to
th~
attention
of
the
Technical Service
Department)
for
the
name and address of
the
nearest Marantz warranty or authorized service
station. Please include
the
model and serial
number
of
the
unit
together
with a description
of
the
problem.
If
it should ever be necessary
to
ship
the
unit
to
the
factory
or
authorized service
station
and
your
Receiver
is
mounted in its accessory
walnut
cabinet, ALWAYS REMOVE THE CABINET
BEFORE PACKING. DO NOT SHIP THE
AC-
CESSORY WALNUT CABINET. Pack
the
unit
carefully, using
the
original packing material.
If
the
packing material has been discarded, lost
or damaged, write
to
the
factory (to
the
attention
of
the
Technical Service Department) for new
packing material. Carton, fillers and packing
instructions will be returned
to
you
at
a nominal
charge.
No Receiver should be returned
to
the
factory
without
an Authorized Return Label, which
the
Marantz Company will supply if
the
description
of
difficulties appears
to
warrant
factory
service.
Please Pack
the
Receiver
as
illustrated
in
Figure
15.
CAUTION
Please
DO
NOT ship
your
Receiver mounted in
its accessory walnut cabinet.
Insure
the
Receiver for full value:
Make sure
that
your
correct
return
address
is
on
the
shipping label.
Ship via a reputable carrier (DO NOT
USE
PARCEL POST).
Be
sure
to
obtain
receipt from
the
carrier.
Figure
15.
Packing
Instructions
20
To Previous Page
Loading...
