Marantz SR5003 - Error Messages

ENGLISH
32
BASIC
CONNECTIONS
BASIC OPERATION
ADVANCED
CONNECTIONS
SETUP
ADVANCED
OPERATION
TROUBLESHOOTING
OTHERS
NAMES AND
FUNCTION
SETUP
ERROR MESSAGES
Displayed Error Cause How to Remedy
MIC SET ERROR!!
AUTO SETUP
AUTO SETUP: START
MAIN ZONE
SURR BACK: 2CH
MIC SETUP ERROR
CHECK MICROPHONE
Audyssey MultEQ
RETURN EXIT
• The microphone is not properly connected. • Connect the included microphone.
• Check the microphone connection.
NOISE ERROR!!
AUTO SETUP
SPEAKERS CHECK:
NOISE ERROR !!
Audyssey MultEQ
RETURN EXIT
• There is too much noise in the listening room to measure properly.
• Volume from the speakers is low.
• During measurement, turn off devices that make noise such as air
conditioners.
• Measure at a time when the surrounding area is quiet.
ANALYZE ERROR!!
AUTO SETUP
SPEAKERS CHECK:
ANALYZE ERROR !!
Audyssey MultEQ
RETURN NEXT EXIT
* Under ANALYZE ERROR, select “NEXT” with the 3/4 cursor
buttons and press the ENTER button. A detail screen like the
following appears on the display.
SPEAKER CONFIG
CHECK !! SPEAKER
FRONT L : YES REV
CENTER : NO
FRONT R : YES REV
SURR.R : NO ERR
SURR.B R : YES ERR
SURR.B L : YES ERR
SURR.L : NO ERR
SUB W : YES
RETURN EXIT
• The speakers required for suitable playback were not detected.
• Speaker polarity is connected backwards.
In the examples at left, the following trouble is detected.
• The polarity of the left and right channels of the front speakers is
backwards ([REV] appears on the display.)
• The surround speaker is not connected ([NO] is displayed), but the
surround back speaker is connected
(In this kind of situation, [ERR] is displayed for all surround and
surround back speakers.)
An error is indicated in addition to the above if the speakers are
connected as follows.
• When using just one surround back speaker, but it is connected to
the surround back R-channel
(To use just one surround back speaker, connect it to the L-
channel.)
• Check the speaker that is indicated as having reversed polarity
([REV] can appear with some speakers even when properly
connected. In such case, ignore the error indication.)
• Check speaker direction and layout
SR5003U1ENG23.indd32SR5003U1ENG23.indd32 08.7.44:48:38PM08.7.44:48:38PM