NAMES AND
FUNCTIONS
17
BASIC
CONNECTIONS
BASIC
OPERATION
ADVANCED
CONNECTIONS
SETUP
ADVANCED
OPERATION
TROUBLESHOOTING
OTHERS
BASIC
OPERATION
ENGLISH
TUNER OPERATION
To operate the unit from the remote controller, press
the TUNE button on the remote controller so that
the tuner mode is engaged.
The unit shown in the illustrations is SR6004.
LISTENING TO THE TUNER
Frequency scan step for AM is selectable.
Default setup is 10 kHz step, if your country’s
standard is 9 kHz step, Press BAND button on the
front panel or BAND button on the remote controller
more than 5 seconds. Scan step will change.
Note
• Preset memory for the tuner will clear by changing
this setup.
AUTO TUNING
1. 2.3.
1.
3.
2.
(Using the unit)
1. Turn the INPUT SELECTOR knob to select
“TUNER”.
2. Press the BAND button to select either FM
or AM.
3. Press the 3 or 4 cursor buttons on the front
Panel for more than 1 second to start the
auto tuning function.
4. Automatic searching begins then stops
when a station is tuned in.
(Using the remote controller)
1. To select tuner, Press the TUNE button
twice within two second on the remote
controller.
2. Press the BAND button to select either FM
or AM.
3. Press and hold the TUNE 3 or 4 button for
1 second or more.
4. Automatic searching begins then stops
when a station is tuned in.
If tuning does not stop at the desired station, use to
the “Manual tuning” operation.
MANUAL TUNING
1. 2.3.
1.
3.
2.
(Using the unit)
1. Turn the INPUT SELECTOR knob to select
“TUNER”.
2. Press the BAND button to select either FM
or AM.
3. Press the 3 or 4 cursor buttons on the front
Panel to select the desired station.
(Using the remote controller)
1. To select tuner, press the TUNE button
twice within two seconds on the remote
controller.
2. Press the BAND button to select either FM
or AM.
3. Press the TUNE 3 or 4 button to tune in the
deseired station.
DIRECT FREQUENCY CALL
1.
2.
4.
3.
1. To select tuner, press the TUNE button
twice within two seconds on the remote
controller.
2. Press the BAND button to select either FM
or AM.
3. Press the F.DIRECT on the remote controller,
display will show “FREQ----”.
4. lnput your desired station’s, frequency with
the ten numbered keypad on the remote
controller.
5. The desired station will automatically be
tuned.
(FM) TUNING MODE (AUTO STEREO OR
MONO)
When in the auto stereo mode, “AUTO” indicator
will be illuminated on the display.
The “ST” indicator is illuminated when a stereo
broadcast is tuned in.
At open frequencies, the noise is muted and the
“TUNED” and “ST” indicators are not illuminated.
If the signal is weak, it may be diffi cult to tune
into the station in stereo. In such a case, Press
the T.MODE button on the front panel or T.MODE
button on the remote controller.
“AUTO” indicator is not illuminated, if FM stereo
broadcasts are received in monaural and the “ST”
indicator is not illuminated.
To return to auto stereo mode, Press the T.MODE
button on the front panel or T.MODE button on
the remote controller again. “AUTO” indicator is
illuminated the display.
BASIC OPERATION
To Next Page
Loading...
Need help?
General
