NAMES AND
FUNCTIONS
50
BASIC
CONNECTIONS
BASIC
OPERATION
ADVANCED
CONNECTIONS
SETUP
ADVANCED
OPERATION
TROUBLESHOOTING
OTHERS
ADVANCED
OPERATION
ENGLISH
ADVANCED OPERATION
CHANNEL DIRECT CALL
You can select the desired channel by directly tapping
the numeric keypads on the remote controller.
1.
2.
3.
4.
1. To select tuner, press the TUNE button
twice within two seconds on the remote
controller.
2. Press the BAND button to select XM band.
3. Press the F.DIRECT button.
“XM - - -” will appear on the display.
4. Input the three digit number for your
desired channel with the numeric keypad
on the remote controller.
5. The desired channel will automatically be
tuned.
Note
If there is no input on the keypad for 5 sec., the input
is cancelled to return to the original display.
Notes
• “LOADING” is displayed while receiving the
channel or information.
• “CH UNAUTH” is displayed while updating
encryption code.
• When the selected channel is not available, “CH
UNAVL” is dispIayed.
• “OFF AIR” is displayed while air is suspended
(e.g. midnight).
PRESET MEMORY
You can store the desired channel in the Preset
Memory.
In addition to AM and FM, it is possible to preset 50
XM Satellite Radio channels.
2. 4.3.
2.
3.
(Using the unit)
1. Tune into the desired channel.
2. Press the MEMORY button on the front
panel.
”- -” (preset number) starts blinking on the
dispIay.
--XM040
3. Select the preset number by pressing the
1 or 2 cursor buttons, While this is still
blinking (approx. 5 seconds)
01XM040
4. Press the MEMORY button again to enter.
The display stops blinking.
The channel is now stored in the specifi ed
preset memory location.
(Using the remote controller)
1. Tune into the desired channel.
2. Press the MEMO button on the remote
controller. “- -” (preset number) starts
blinking on the display.
3. Enter the desired preset number by pressing
the numeric buttons.
Note
When entering a single digit number (2 for example),
either input “02” or just input “2” and wait for a
few seconds.
CHECKING THE XM PRESET CHANNEL
The preset channel can be checked on the on
screen display.
2.
3.
4.
1.
(Using the remote controller)
1. To select tuner, press the TUNE button
twice within two seconds on the remote
controller.
2. Press the BAND button to select XM band.
3. Press the INFO button. to view a list of tuner
preset channeI on the on screen display.
4. If there are 10 or more preset channel,
press the INFO button again.
XM PRESET LIST
NO. 1 XM010 XXXXXXXXXX
NO. 2 XM011 XXXXXXXXXX
NO. 3 XM015 XXXXXXXXXX
NO. 4 XM022 XXXXXXXXXX
NO. 5 XM125 XXXXXXXXXX
NO. 6 XM001 Preview
NO. 7 XM001 Preview
NO. 8 XM001 Preview
NO. 9 XM001 Preview
NO.10 XM001 Preview
Note
The preset channel indication disappears in about
5 sec.
To Next Page
Loading...
Need help?
General
