Marantz SR6006/U1B - Page 74

74
Surround
Surround mode
Surround Parameters
Tone
z8
Audyssey Settings
z9
Audyssey DSX™
z9
M-DAX
z12
Height Gain
z7
PRO LOGIC g/gx Music mode only
NEO:6 Music
mode only
Panorama Dimension Center Width Center Image MultEQ
®
XT
Dynamic EQ
®
z10
Dynamic
Volume
®
z11
DIRECT/PURE DIRECT (2channel)
z1
DIRECT/PURE DIRECT (Multi-channel)
z1
STEREO
S S S S S
MULTI CH IN
S S S S S S
DOLBY PRO LOGIC gz S S S S S S DOLBY PRO LOGIC gx S S S S S S S S S
DOLBY PRO LOGIC g S S S S S S S S S
DOLBY PRO LOGIC g A-DSX S S S S S S S S S
DOLBY PRO LOGIC A-DSX
S S S S S S S S S
DTS NEO:6
S S S S S S S
DTS NEO:6 A-DSX
S S S S S S S
Audyssey DSX™
S S S S S
DOLBY DIGITAL
S S S S S S
DOLBY DIGITAL Plus
S S S S S S
DOLBY TrueHD
S S S S S S
DTS SURROUND
S S S S S S
DTS 96/24
S S S S S S
DTS-HD
S S S S S S
DTS Express
S S S S S S
MULTI CH STEREO
S S S S S S
VIRTUAL
S S S S S
z1 During playback in PURE DIRECT mode, the surround parameters are the same as in DIRECT mode. z7 This item can be set when surround mode is “PLgz” or PLgz decoder is used. z8 This item cannot be set when “Dynamic EQ
®
” is set to “ON”.
z9 For HD Audio whose sampling frequency of an input signal is more than 96 kHz, this sound parameter cannot be set. z10 This item cannot be set when “MultEQ
®
XT” is set to “OFF” or “Manual”.
z11 This item cannot be set when “Dynamic EQ
®
” is set to “OFF”.
z12 This item can be set when the input signal is analog, PCM 48 kHz or 44.1 kHz.
2