Marathon Electric DVR 2000E+ - Page 35

33
5
Applying voltage larger than 120 Vac with-
out current in-rush limiting may damage the unit.
2. If the regulator is in AVR1 or AVR3 regulation
mode, the regulator will indicate RUN on the
display. If the regulator is in FCR regulation
mode, the regulator will indicate F011 on the
display.
3. At this time, initial adjustments can
be made.If adjusting via the HMI, see
Section 6 – Making Settings Changes. If
adjusting via the Windows
®
communication
software, see Section 7.
After the initial adjustments are made, disconnect
the 120 Vac source and install the regulator onto the
generator. The generator may be started and final
adjustmentsmaybeperformedontheregulator.
Installation
GPN046 04-13.indd 33 4/5/13 10:24 AM