37
MAKING SETTINGS CHANGES
1. The default state of the HMI display is SLEEP
mode. The HMI will enter the SLEEP mode
after 60 seconds of inactivity (no button
presses). Any HMI button press will place
the HMI into STATUS mode. In order to
make changes to settings, the following pro-
cedure is used:
2. Repeatedly press the SELECT button,
stepping through the main menu until the
desired parameter is displayed (see Table
6-3). If no button is pressed within 60 sec-
onds, the display will return to STATUS
mode.
3. Press the ENTER button to place the HMI
into EDIT mode. In EDIT mode, the HMI will
display the current value of the selected
parameter.
4. Press or hold the UPand DOWNbut-
tons to modify the displayed parameter to
its desired value. Parameter changes takes
immediate effect. For parameters other than
STPT, pressing the SELECT button es-
capes EDIT mode without modifying
the parameter. For STPT, pressing the
SELECT button escapes EDIT mode but
preserves any modification.
5. To store the displayed parameter value to
non-volatile memory, press the ENTER
button. The stored parameter value will flash
three times to confirm the entry.
NOTE: While in STATUS mode, pressing either the
UP or DOWN button places the regulator directly
into STPT EDIT mode. This feature allows a shortcut to
set point adjustment.
6
Human-Machine Interface (HMI)
h
•
i
;
•
•
;
h
i
GPN046 04-13.indd 37 4/5/13 10:24 AM
To Next Page
Loading...
