31
Marathon Electric (a division of RBC Manufacturing Corp.) reserves the right to change specications and this manual without notice.
Revised 06/2011
NOTESk:
1. Excitation enabled when switch is open and disabled when switch is closed. Switch supplied by others.
2.SPDT,springreturntocenter-offpositiontypeswitchforremotesetpointadjust.Switchsuppliedbyothers.
3. Droop enabled when switch is open and disabled when switch is closed. Switch supplied by others.
4. Normally open contact closes in a fault condition.
5. Analog signal input when Auxiliary is configured for control or metering.
6. Should be shorted when Auxiliary is configured as 4-20 mA metering input.
7. Sensing potential transformer is required if generator output voltage exceeds 600 Volts.
Figure 4-8. Typical Connections with ABC Rotation, Three-Phase Voltage Sensing and
Single-Phase Current Sensing