MAREX 375
70
by Nikl Design USER MANUAL
7.0 PREPARING FOR THE SEASON
7.1 GENERAL PREPARATION
✓ Take off the canopy in due time and ventilate the boat thoroughly before the boat
is placed on water. Wash and polish the boat. Apply antifouling under the
waterline.
✓ Replace the batteries and refill the water level. Check/measure the capacities,
cables and cable shoes. Check the hoses and other joints. Control that the
instruments and navigation lights are functioning.
✓ Check that all valves in the hull are working and that the hoses are properly
fastened.
✓ Check that all filters are airtight:
• fresh water filter
• shower pump filter
• toilet water inlet
✓ Close all draining plugs. Check that bottom valves for seawater cooling is open.
Check that pipes and water taps are closed.
Adjustments on the engine feet/fundaments must only be performed by authorized
personnel. The bolts are glued to the fundaments. By any adjustments you will damage
the glue. If the feet/bolts are loose, contact a serviceman immediately.
CAUTION
Check for potential frost damages.
7.2 PREPARING THE ENGINE AND THE DRIVE
✓ Control the new oil level (the oil must be changed). See the engine’s user manual.
✓ Control the drives new oil level (the oil must be changed). See the drives user
manual.
✓ Control the fuel filter and change it if necessary. Control the fuel system and
fasten all couplings and fittings. Check the water separator. Look for any
damages or leakages or potential hazard. See the engine’s user manual.
✓ Check the through hull fittings. Control all couplings and fittings.
✓ Check the propeller.
7.3 PREPARING THE STEERING
To Next Page
Loading...