Model WT3-201 Wire Crimp Pull Tester User’s Guide
19
Displayed at the start of calibration if a disallowed unit is selected.
Ensure that the load is not swinging, oscillating, or vibrating in any manner. Then try again.
The calibration weight does not match the set value.
The entered calibration point is too close to the previous point.
13 PASSWORDS
Two separate passwords may be set to control access to the Calibration section and to the menu and
other keys. To access the passwords setup screen, select Passwords from the menu. The display
appears as follows:
PASSWORDS
Calibration
MENU Key
MODE Key
ZERO Key
DATA Key
CALIBRATION
Load too close
to previous.
Please try again.
CALIBRATION
Load not stable.
Please try again.
CALIBRATION
Units must be lbF.
Please try again
Press ENTER.
CALIBRATION
COMPRESSION
Load too low.
Please try again.
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com
To Next Page
Loading...
