Need help?Do you have a question about the Mark-10 ESM303 and is the answer not in the manual?
General| Type | Motorized Test Stand |
|---|---|
| Maximum Force | 300 lbF |
| Maximum Force Capacity | 300 lbF |
| Units of Measurement | lbF, N, kgF |
| Data Output | USB, RS-232 |
| Voltage | 100-240V AC |
| Test Frame Type | Vertical |
| Interface | USB, RS-232 |
| Capacity | 300 lbF (1.5 kN) |
| Display | LCD |
| Maximum Travel | 18 in (450 mm) |
| Software | MESURgauge |
| Speed Accuracy | ±0.2% of setting |
| Weight | 21 kg [46 lb] |
Instructions for placing and securing the test stand on a clean, flat, level work area for stability.
Steps to properly install the control panel and mounting bracket for the test stand.
Guidelines for safe operation, material compatibility, and general precautions.
Procedure for safely connecting the test stand to a power source and associated checks.
Essential safety checks and procedures to perform before and during test stand operation.
Procedure for lubricating the ball screw to ensure optimal performance and longevity.
Details common error messages and their respective causes and solutions.
Identifies potential causes and troubleshooting steps for crosshead movement issues.
To Next Page
