Mark-10 ESM303 - Programmable Button Function (KEYS); Followme

Models ESM303 & ESM303H Test Stands User’s Guide
22
4.13 Programmable button function (KEYS)
Three button function modes are available:
1. Maintained
The crosshead will move continuously once the button has been pressed and held.
Subsequently pressing STOP will stop crosshead motion.
2. Momentary
The crosshead will move only if the button is held down. Releasing the button will stop
movement immediately.
3. Auto
Holding down the button for more than 0.5 second will enter momentary mode, at which time
an audible indicator will sound and the LED indicator on the button pushed will be illuminated.
A short tap on the button will operate the test stand in maintained mode. Pressing STOP
during maintained mode will stop crosshead motion.
Default setting: auto
Available settings: maintained, momentary, auto
Label
Description
+ or –
Cycles through the available settings
ENTR
Returns to the Test Function Setup menu
ESC
Exits the function without saving changes
4.14 FollowMe
TM
Crosshead responds to manually pushing or pulling on the force gauge shaft or load cell. Increasing force
produces greater speeds. Ideal for quick positioning during sample loading and unloading.
CAUTION!
Exercise extreme caution when handling low capacity force gauges and
sensors, as overload can occur.
Default setting: OFF
Available settings: ON, OFF
Label
Description
+ or –
Cycles through the available settings
ENTR
Returns to the Test Function Setup menu
ESC
Exits the function without saving changes
K
E
Y
S
:
M
A
I
N
T
A
I
N
E
D
E
S
C
−
+
E
N
T
R
F
O
L
L
O
W
M
E
:
O
F
F
E
S
C
−
+
E
N
T
R