Mark-10 ESM303 - Default Settings; Password (NEW PWORD)

Models ESM303 & ESM303H Test Stands User’s Guide
24
4.16 Default settings
Revert to the following factory settings:
SPEED: 10 in/min
UP / RIGHT SPEED: 10 in/min
DOWN / LEFT SPEED: 10 in/min
AUTO RETURN: off
CYCLING: 00000 (off)
HI / RIGHT LIMIT: +20.000 in
LO / LEFT LIMIT: -20.000 in
OVERLOAD PROTECTION: off
PRELOAD: off
LOAD HOLDING: off
BREAK DETECTION: off
PROFILE: DEFAULT
CONTROL: CONSOLE
BAUD RATE: 115200
STOP BITS & PARITY: 8-1n
UNIT: in/min
KEYS: auto
FOLLOWME: off
PASSWORD: 0000 (off)
If the PROFILES function is installed, the test stand will revert to the profile named “DEFAULT”. This
profile contains the factory settings listed above, and may not be edited.
If the PROFILES function is not installed, the display appears as follows:
Label
Description
+ or –
Cycles through “yes” or “no” selections
ENTR
Returns to the Test Function Setup menu
ESC
Exits the function without saving changes
4.17 Password (NEW PWORD)
If desired, a password can be set to prevent unwanted changes to test functions. The password can be
set to any number between 0000 and 9999. The default setting of 0000 indicates that the password is
disabled, and that the user can freely enter the Test Function Setup menu. If misplaced or forgotten, the
password may be reset through a code activation process. Details on this may be found in the Function
Activation section.
Default setting: 0000 (off)
Available settings: 0000 – 9999
Label
Description
+ or –
Increases or decreases the value.
ENTR
Returns to the Test Function Setup menu
ESC
Exits the function without saving changes
D
E
F
A
U
L
T
?
:
N
O
E
S
C
−
+
E
N
T
R
N
E
W
P
W
O
R
D
0
0
0
0
E
S
C
−
+
E
N
T
R