Mark-10 ESM303 - Followme Mode; PC Control Mode

Models ESM303 & ESM303H Test Stands User’s Guide
26
1. Basic & Auto Return Modes (travel indication option not installed):
2. Basic & Auto Return Modes (travel indication option installed):
3. Cycling Mode (travel indication option not installed):
Note:
The min and max keys will not appear when a password has been set.
4. PC Control Mode
Appears the same as in Basic and Auto Return modes.
Label
Description
menu
Enters Test Function Setup
min
Sets speed to minimum speed. Will not appear when a
password has been set.
max
Sets speed to maximum speed. Will not appear when a
password has been set.
set
Sets speed to the programmed value.
Pressing menu will enter Test Function Setup. If a password has been programmed, the display
will prompt the following:
The password is a four digit number. Press + or – to increment or decrement the number. Once
the complete password has been entered, press ENTR. If correct, the display will enter the Test
Function Setup menu. If the password is incorrect, the display flashes “INCORRECT
PASSWORD”, and then reverts to Operating Mode.
5.3 FollowMe
TM
mode
Crosshead movement responds to manually pushing or pulling on the force gauge shaft or load cell.
Increasing force produces greater speeds. Ideal for quick positioning during sample loading and
unloading. To arm FollowMe
TM
mode, press the FollowMe
TM
key. The display appears as follows:
S
P
E
E
D
:
0
.
0
0
m
e
n
u
m
i
n
m
a
x
S
E
T
1
.
2
7
5
0
.
0
0
m
e
n
u
m
i
n
m
a
x
S
E
T
C
Y
C
L
E
S
:
0
0
0
2
4
m
e
n
u
m
i
n
m
a
x
S
E
T
P
A
S
S
W
O
R
D
0
0
0
0
E
S
C
−
+
E
N
T
R
POSITION
SPEED