Mark-10 ESM303 - Test Function Setup and Configuration

Models ESM303 & ESM303H Test Stands User’s Guide
13
DEMO MODE
The ESM303 is shipped in Demo Mode, during which time all available functions are
temporarily activated for 160 hours of operation. At power-up, a counter displays the
number of hours remaining, as follows:
Press STOP to continue.
At the end of this period, any functions not originally purchased will be deactivated,
and will no longer be accessible from the Test Function Setup menu. Demo Mode
can be suspended at any time by pressing and holding STOP while turning on power
to the test stand. This mode can be re-enabled in the same manner, and will be
active for the remaining time period.
Refer to the Function Activation section for instructions for field activation.
R
E
M
A
I
N
I
N
G
D
E
M
O
T
I
M
E
:
1
6
0
H
O
U
R
S
4 TEST FUNCTION SETUP
This section provides configuration instructions for each function.
Function
Standard / Optional
Travel indication
Optional
Speed - same setting applies to both directions
Standard
Independent up and down speeds
Optional
High speed range extension
Optional
Low speed range extension
Optional
Auto return
Optional
Cycling with dwell time
Optional
Programmable travel limits
Optional
Overload protection
Optional
Preload
Optional
Loadholding
Optional
Break detection
Optional
PC control
Optional
FollowMe
TM
Optional
Profiles
Optional
Communication settings
Standard
Speed / distance unit of measurement
Standard
Directional button configuration
Standard
Password protection
Standard
All ESM303 test stands are supplied in Demo Mode, as explained in the Overview section. After Demo
Mode expires, only installed functions will be displayed in Test Function Setup. To access Test Function
Setup menu, press menu from the Operating Mode home screen, which appears as follows:
S
P
E
E
D
:
0
.
0
0
m
e
n
u
m
i
n
m
a
x
S
E
T