Model WT3-201 Wire Crimp Pull Tester User’s Guide
22
Press ENTER to modify the contrast. Select a value from 0 to 25, 25 producing the most contrast.
14.4 Tones
Audible tones can be enabled for all key presses and alerts, such as overload, set point value reached,
etc. The Set Point alert can be configured to be either a momentary tone or a continuous tone (until the
load is restored to a value between the set points). To configure the functions for which audible tones will
apply, select Tones from the menu. The screen appears as follows:
14.5 Initial settings
This section is used to configure the initial settings upon powering on the tester. The initial units of
measurement and the primary reading measurement mode may be configured. To access these settings,
select Initial Settings from the menu. The screen appears as follows:
The default values are lbF and Real Time.
14.6 Restore Default Settings
Default factory settings can be restored by selecting Restore Defaults from the menu. The settings may
be found in the Specifications section. The display appears as follows:
RESTORE DEFAULT
SETTINGS?
No
Yes
INITIAL SETTINGS
Units
lbF
Mode
Real Time
TONES
Keys
* Alerts
Set Points
* Momentary
Continuous
LCD CONTRAST
Set Contrast
10
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com
To Next Page
Loading...
