Mark Levinson 32 - Page 78

I-2
Mark Levinson
IR transmitter, 2-11
IR transmitter LED, 2-11
mono button, 2-11, 2-12
mute button, 2-11, 2-12
polarity button, 2-11, 2-12
position, 5-1
select buttons, 2-11, 2-12
setup button, 2-11
standby button, 2-11, 2-13
volume buttons, 2-11, 2-13
residual noise, A-2
RS-232 port, 2-5, 2-8
S
select buttons, 2-11, 2-12
select knob, 2-1, 2-2
setup button, 2-2, 2-4, 2-11
setup LED, 2-2, 2-4
setup menu
enter button, 3-2
input selection, 3-3
select buttons, 3-2
select knob, 3-2
set inputs parameters
gain, 3-3, 3-7
name, 3-3, 3-4
offset, 3-3, 3-7
rec. out, 3-3, 3-7
setup button, 3-2
setup parameters
maxvol, 3-10
mute, 3-10
sw, 3-11
trig, 3-11
teach IR, 3-8
volume buttons, 3-3
volume knob, 3-3
shipping weight, A-2
slave chain, 4-14, 4-16
sleep timer, 4-1
software version number, 5-4
specifications
controller connectors, A-1
crosstalk, A-2
frequency response, A-2
gain, A-1
gain resolution, A-2
input impedance, A-2
input overload, A-2
maximum main output, A-2
operating voltage, A-1
output impedance, A-2
overall dimensions, A-2
power consumption, A-1
preamplifier connectors, A-1
residual noise, A-2
shipping weight, A-2
THD + N, A-2
volume control range, A-1
SSP mode, 4-10
standby button, 2-1, 2-2, 2-11, 2-
13
standby mode
sleep timer, 4-1
Surround Sound Processor. See
SSP mode
sw parameter, 3-11
T
teach IR, 3-8
THD + N, A-2
trig parameter, 3-11
trigger input connector, 2-6, 2-9
trigger output connector, 2-6, 2-9
trigger output signal, 3-11
troubleshooting
"missing" input, 5-2
audible hum, 5-3
erratic behavior, 5-3
if all else fails, 5-3
no IR learning, 5-2
no link controls, 5-3
no main output, 5-2
no power, 5-1
no remote control operation,
5-1
U
unbalanced input connectors, 2-
5, 2-7
V
volume buttons, 2-11, 2-13
volume control range, A-1
volume knob, 2-1, 2-3