Marksman X6 - Keyless Entry Feature Programming

18
One Chirp Two Chirps Three Chirps Four Chirps
Button One LED Pulse Two LED Pulses Three LED Pulses Four LED Pulses
(Default Setting)
With the ignition switch in the OFF position, turn the
ignition switch On - Off - On - Off - On - Off.
Before 15 seconds has passed, push and release the
valet switch 2 times holding the button down on the
2nd press. Wait until you hear 1 short and 1 long
chirp/beeps. Release the button. You
are now in “Alarm
Feature Programming (Group 1)” mode.
Step 1 Step 2
3X
1X + 1X (Hold)
Step 3
Remote Feature Programming
Press the transmitter buttons as illustrated to adjust the features required. Keep re-pressing the transmitter button
that relates to the feature you want to adjust until the correct amount of chirp/beeps is heard then move on to the
next feature.
All Chirps On All Chirps Off
Parking Light On for 30 sec.
after Unlock Signal
Parking Light On 10 sec.
after Lock and 30 sec. after
Unlock
Pathway Illumination
Off
HC4 Light Blue Wire:
2nd Unlock Output
HC4 Light Blue Wire:
Fact. Security disarm Output
HC2 Brown Wire:
(-) Horn Output
HC4 White Wire:
(-) Domelight Supervision
Output
HC4 White Wire:
(-) Output During Starting
Normal Horn Output
Pulse Duration
PVID 1
Horn Output
S-S-S - L-L-L - S-S-S
PVID 2
Horn Output
S-L-S-L
PVID 3
Horn Output
S-S-S-L
PVID 4
Horn Output
S-M-L-S-M-L
PVID 5
Horn Output
S-S - L - S-S
Five Chirps
Five LED Pulses
Six Chirps
Six LED Pulses
Keyless Entry Feature Programming (Group 1)
HC4 Light Blue Wire:
Start Status Output
HC2 Brown Wire:
Fact. Security Re-arm Output
X6-IM.qxp 9/12/2008 1:50 PM Page 18
+
+