Page 23
Call mode settings:
Telephone number 1…Telephone number 5: Number that the unit will call when call
button pressed.
Delay before dialing next no. on the list: Time delay in second before next user on the list
gets dialed if the call to the previous user is not answered.
Extension number: Parameter is used to set the DTMF number in auto self-select function
Extension no. delay: Parameter is used to set the delay (in sec.) for sending DTMF number
in auto self-select function.
Work time start, Work time end: Parameters are used to define work time schedule.
Inside this limits number under position 1 to 4 will be dialed, outside this limits number
under position 5 will be dialed.
Call point sound settings
Microphone level: Increasing the level will increase the sensitivity of the unit microphone
decreasing will decrease the sensitivity.
Speaker level: Increasing the level will increase the volume of the unit speaker, decreasing
will decrease the level of the speaker.
Ringing sound: By selecting Playing the unit will play the dial tone in the connection phase
of the call, by selecting Muted the unit will not play any sound in the connection phase of
the call.
On activate input: By selecting Play beep sound (buzzer) the unit will provide audio feed
back (buzzer BEEP) when the apartment entry is selected, by selected Muted unit will
provide no audio feedback when the apartment entry is selected.
To Next Page
Loading...