4
OPERATION
The Model 2000 has two operating modes: Real-Time and Recall. In the Real-Time operating mode,
Real-Time velocities from the sensor are displayed. In the Recall operating mode, velocities from
memory are displayed.
Comment
In the Recall mode, the time bar will be stationary.
Real-Time Operating Mode
The unit will always power up in the real-time operating mode. From the real-time mode you can
change the filter value, store readings in memory, turn the beeper on or off, alternate between feet per
second (ft/s) and meters per second (m/s), alternate between fixed point averaging and time constant
filtering, and switch to the recall operating mode.
Display ON Sequence
When the unit is turned ON, the display output sequence is as follows:
• Software version number. This is the Model 2000 operating software that was burned into the
electronics at the factory.
• Display segment test. The unit will light all display segments.
• Velocity output. The first few readings are not filtered; however, they are accurate.
To Next Page
Loading...