© Martin Engineering GmbH 36 M3682UK-09/17
Maintenance
6. Follow the instructions in Section 5.3 to replace any worn out
blades.
7. Clean all the warning labels. Replace illegible warning labels
immediately. Warning labels can be purchased from Martin
Engineering or a contracted dealer.
8. Remove all tools from the working area.
9. Switch on the conveyor system.
NOTE
Take the corresponding parts of the conveyor system out of
service if any indications of functional disturbances are noticed.
Contact Martin Engineering or one of its representatives for
support. Do NOT start up the conveyor system until the cause of
the problems has been recognised and eliminated.
CAUTION RISK OF DAMAGE!
The SAF-3 blades must not be worn out beyond the wear line; this
can cause serious material damage.
Inspect the blades regularly and replace them in a timely manner!
CAUTION RISK OF DAMAGE!
The SQC2 blades with tungsten-carbide inserts must not be
completely worn out up to their metal edge; this can result in
serious damage.
Inspect the blades regularly and replace them in a timely manner!
CAUTION FLYING OBJECTS!
Forgotten tools or installation parts can fall off of the running
conveyor belt and cause minor injuries and property damage.
Always remove any tools from the installation site and conveyor
belt upon completion of the installation work before switching on
the power supply.
To Next Page
Loading...