Why is my Martin SQC2 Ultrasonic Jewelry Cleaner making noises and vibrations?
If your Martin Ultrasonic Jewelry Cleaner is making unusual noises or vibrations, it could be due to a couple of things. First, check the tension of the cleaner on the conveyor belt; it might be too loose or too tight, so correct the tension as needed. Also, ensure that the blade is correctly aligned with the conveyor belt.
What to do if my Martin SQC2 has insufficient cleaning performance?
If your Martin Ultrasonic Jewelry Cleaner isn't cleaning well enough and you're seeing material accumulation, it could be because the cleaner isn't tensed enough or is tensed too tightly on the conveyor belt. Try increasing or reducing the tension. Also, inspect the blades and replace them if necessary, following the instructions in the “Weekly maintenance” section.
Why does my Martin Ultrasonic Jewelry Cleaner have an unusual pattern of wear or damage to the blade?
An unusual wear pattern or damage to the blade of your Martin Ultrasonic Jewelry Cleaner could stem from a few causes. Inspect the conveyor belt's connection points and repair or replace them as needed. Another reason might be that the cleaner is installed in the material flow; try installing the pre-cleaner in a different place. Finally, check the tension values of the In-line-Reversing tensioner and possibly re-tighten them.
How to prevent high wear on the blades of Martin Ultrasonic Jewelry Cleaner?
High wear on the blades of your Martin Ultrasonic Jewelry Cleaner might be happening because the cleaner is too tightly tensed on the conveyor belt. Reduce the tension; you can find the correct tension values in fig. 22, page 28.
Emphasizes reading instructions and ensuring safety during work.
Emphasizes reading safety information before starting any installation work.
Outlines the steps involved in the overall installation of the secondary cleaner and tensioner.
Details how to determine the correct placement for the cleaner and tensioner.
Provides step-by-step instructions for installing the tensioner assembly.
Details the procedure for installing the main cleaner unit.
Explains how to properly center the cleaner's mainframe under the conveyor belt.
Guides on ensuring the cleaner's mainframe is parallel to the conveyor belt.
Details the process for horizontally aligning the cleaner's mainframe.
Provides instructions on securing the secondary cleaner to the installed components.
Explains how to properly tension the secondary cleaner for optimal performance.
Guides on performing a test run to verify correct installation and operation.
Provides essential safety precautions before performing any maintenance tasks.
Outlines the process and precautions for replacing worn or damaged blades.
Provides safety advice relevant to troubleshooting procedures.
Lists common symptoms, their causes, and recommended remedies for troubleshooting.
General| Model | SQC2 |
|---|---|
| Type | Ultrasonic Jewelry Cleaner |
| Frequency | 42 kHz |
| Power | 35W |
| Heating Function | Yes |
| Tank Material | Stainless Steel |
| Material | Plastic and Stainless Steel |
| Tank Capacity | 600 ml |
| Power Supply | 110-120V, 60Hz |
To Next Page