Marzocchi MX Comp ETA 2005 - Removing Fork Seals

The ETA cartridge (5) has been sealed through machining and cannot be overhauled. In the
case of faults or a malfunctioning, this cartridge must be replaced.
Dismantling: Removing the seals
Prize the dust seal (1) off its seat with a small flat-tip screwdriver.
Take great care not to damage the internal surfaces of the one-piece assembly while
removing the dust seal.
With the same screwdriver, prize off the metal stop ring (2).
Take great care not to damage the internal surfaces of the one-piece assembly while
removing the stop ring.
Protect the upper part of the slider with the special tool (A).
With a screwdriver, prize off the sealing ring (3).
Remove the sealing ring (3).
Take great care not to damage the internal surfaces of the one-piece assembly while
removing the sealing ring.
© Marzocchi Suspension
2005 - MX Comp ETA