Marzocchi MX Comp ETA 2005 - Assembling Top Right Cap

Assembling: Assembling the top right cap
Put the fork in the vice in vertical position, fixing it by the dropouts.
Check that O-ring is not damaged.
Using the 21mm socket spanner, tighten cap (2) to the recommended tightening torque (10 Nm ± 1).
Restore the correct air pressure (see settings).
Fit the protection cap (1).
Assembling: Assembling the top right cap
Put the fork in the vice in vertical position, fixing it by the dropouts.
Check that O-ring is not damaged.
Using the 21mm socket spanner, tighten cap (2) to the recommended tightening torque (10 Nm ± 1).
Restore the correct air pressure (see settings).
© Marzocchi Suspension
2005 - MX Comp ETA