Marzocchi MX Comp ETA 2005 - Filling with Oil

Using introducer (A) insert the dust seals (11) in their seats.
Assembling: Filling with oil
Block the fork in the vice, in perfectly vertical position.
Lower the crown-stanchion unit on the arch-slider assembly.
In a graduated recipient, prepare the quantity of oil to pour into the fork leg (see table).
Pour roughly 1/3 of the oil required into each stanchion, then pump the fork a few times to eliminate any
traces of air.
Pour the rest of oil in.
A lower or higher volume or a type of oil other than the one recommended can change the behaviour of the fork in every phase.
Lift the crown-stanchion unit on the arch-slider assembly.
© Marzocchi Suspension
2005 - MX Comp ETA