Mase Generators IS 9 - REFERENCE DOCUMENTS; REFERENCE REGULATIONS AND LEGISLATIVE PROVISIONS; MARKING; IDENTIFICATION OF THE GENERATOR UNIT

IS 9
- 15
GB
GB
KVA
Hz
Cos.
Ø
VV
AA
Degrees of protection IP
°C
m
Performance class
year of manifacture
Rated power factor
Rated voltage
declared frequency
Mass Kg
Class of insulation
Temp. max of use
Altitude max. of use
Rated current
Rated power 3F
Code Serial n°
1
2
5
4
14
6
7
8
9
10
11
12
13
15
16
3
1.6 REFERENCE DOCUMENTS
The instructions for use provided with each generator
are made up of a collection of documents of which this
manual represents the General Part. The following
documents are normally provided separate.
aCE declaration of conformity.
b Instruction manual for use and maintenance of
the generators,(this manual).
c Engine use and maintenance manual.
d List of mase Service Centres.
e mase Warranty certificate.
f Warranty card.
g EPA certificate (Engine manufacturing)
1.7 REFERENCE REGULATIONS AND LEGISLATIVE PROVISIONS
The generator groups, built by mase, destined to the
countries of the European Community, are conforming
to the applicable EC directives, and they are provided of
a EC Declaration of Conformity.
EN 12601: Reciprocating internal combustion engine
driven generating sets.
98/37/EC and subsequent amendments:
Essential machine requirements for safety and health
protection (“Machine” directive).
73/23/EC and subsequent amendments contained in
the directive 93/68/EC : Guarantee of safety of electrical
material intended for use within certain voltage limits,
(“Low Voltage” Directives).
EN 60204.1: Electrical equipment of machines.
1.8 MARKING
The generator identification plate carries all the
identification data conforming to ISO 8528 and in
accordance with the provisions for EC marking for
those cases where required. Below is a facsimile of the
identification plate fixed on the hull of each generator.
1.9 IDENTIFICATION OF THE GENERATOR UNIT
1 - Machine name
2 - Machine code
3 - Serial number
4 - Rated power
5 - Declared frequency
6 - Rated power factor
7 - Rated voltage
8 - Rated current
9 - Degree of protection
10 - Class of isolation
11 - Temperature max. of use
12 - Altitude max. of use
13 - Performance class
14 - Year of construction
15 - Manufacturer - Adress
16 - Weight
The machine code number, the serial number
and the year of construction must always be
indicated when contacting the manufacturer
for information, order of spare parts, etc..