model no. 046-0265-2 | contact us 1-800-689-9928
INSTALL THE HEADER BRACKET
Attach the Header Bracket
Place the bottom edge of the bracket on the line marked above the highest point of travel.
Note the orientation of the header bracket. Do not mount it upside down.
Ceiling Installation
The header bracket may be mounted to the
ceiling if there is minimal clearance above the
door. If so, extend the centreline to the ceiling.
The back edge of the bracket must not be
further than 5" (12.7 cm) from the header wall.
1 1/4" (3 cm) Above Sectional Door/
7" (18 cm) Above One-piece Jamb Door
Highest Point of Travel
Mark the 2 holes with
a pencil.
Drill two 3/16" (5 mm) pilot holes.
Attach the header bracket with
2 lag screws provided.
5" (12.7 cm)
To Next Page
Loading...
Need help?
General
