10. Check and adjust the AC settings.
In Energy Save Mode the power
consumption will be reduced when
there is no load on AC OUT. Please
note that small loads, such as the
clock on a microwave oven, are most
likely not to work in this mode.
See section 3.2 for a description of
AC IN Support.
For a description of instances and
PGNs, please refer to the CZone
Configuration Tool Instruction
manual.
11. Press OK to return to the Advanced
Settings window.
14. Select the required Alarm Severities.
15. Press OK.
Optionally configure digital switching by
adding Circuit Controls in the Circuits tab
(e.g. a battery low switch can be used to
start a generator). Write the configuration
to the network to use the new
configuration.
For more information, please refer to the CZone
®
Configuration Tool Instruction manual.
Also see section 5.2. for a description of the same settings in MasterAdjust.
To Next Page
Loading...
