Wall Mount
1. Use the screws to mount the Drip shield and the product on the wall.
2. Please make sure the height from the ground to product at least 70 cm (28”).
The bulkhead size requires at least 4" (100mm) clearance each side of the inverter.
Step 3. Connect the chassis ground terminal to the central grounding point.
Step 4. Connect the AC wiring to the screw terminals. Fasten the cables with a clip.
Step 5. Integrate a fuse holder in the positive battery wire but do not place the fuse yet!
Step 6. Fit crimp-on ring terminals (
5
/
16
" / M8) to the DC cables. Connect the DC cabling of the
battery bank; positive to +, negative to – .
To Next Page
Loading...
