32 Matrox Display Wall – User Guide
Connecting your Mura IPX Series capture
card
This section describes how to connect your Mura IPX Series 4K Capture and IP Encode/Decode and
your Mura IPX Series 4K Capture and IP Decode card.
Once all your cards are connected, restart your system and install your Matrox software (see
“Installing your software”, page 50).
Supported hardware More information
Input/Output
Mura MPX-4/4, MPX-4/2 See page 36.
Mura MPX-SDI See page 38.
Input
MURAIPXI-E2MF, MURAIPXI-E2MHF See page 33.
MURAIPXI-E4JF, MURAIPXI-E4JHF,
MURAIPXI-D4JF, MURAIPXI-D4JHF
See page 34.
Mura MPX-V16, MPX-V8 See page 42.
Output
Mura MPX-4/0 See page 40.
C900 See page 45.
C680 See page 46.
Console
P690 PCIe ×16 See page 71.
P690 Plus LP PCIe ×16
(dual-monitor cable)
See page 72.
P690 Plus LP PCIe ×16
(quad-monitor cable)
See page 74.
M9120 PCIe ×16, M9125 PCIe ×16 See page 75.
M9120 Plus LP PCIe ×1 / ×16 See page 76.
M9140 LP PCIe ×16 See page 77.
M9128 LP PCIe ×16 See page 78.
M9138 LP PCIe ×16, M9148 LP PCIe ×16 See page 79.
Note
: To make sure your cables are securely attached to your Matrox cards, use a cable retention
bracket. To purchase a cable retention bracket, contact your Matrox representative. For more
information, see “Appendix C – Matrox secure cable solution”, page 81.
To Next Page
Loading...
