EasyManua.ls Logo

Max-Air Systems CAPR - Unpacking 2365-02 SM and 2365-02 ML DLC (Disposable Lens Cuff)

Default Icon
100 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Page 30 P/N 03521015 Rev K
4.7 Unpacking 2365-02SM and 2365-02ML DLC (Disposable Lens Cuff)
1. Open the dispensing end by grasp-
ing the box end with your left hand
as shown and push through the top
curved perforation line.
2. Pull the top-end piece off and away
from the box.
3. Brace the right-side end piece with
your right hand. Pull the left-side end
piece along its perforation line,
tearing downward.
4. Pull the left-side end piece down
and off the box.
5. Lift the box a few inches with your
right hand. Tear off the small bottom-end
piece at its perforation line.
6. When nished, the dispensing box
should be as shown above.
7. To Dispense, merely reach in and
grasp the end of the top DLC and pull
slightly up and out.
8. Position a SM DLC box on top of a
ML DLC box as indicated above.
9. Dispensing DLCs from the top or bot-
tom box is easy and prompt.
Carefully inspect the DLC boxes to ensure there is no
physical damage to the boxes and contents. Report any
damage to the shipper immediately for resolution.
Contact Customer service 1-800-443-3842, if you have
questions.
NOTE
DLC Boxes are 2 sizes,
Long (placed on bottom) for the
larger 2365-02ML, and Short
(placed on top) for the smaller
2365-02SM. Stack as shown for
easy dispensing.

Table of Contents