Page 58 P/N 03521015 Rev K
Dofng the System: Alternative B
1. With the System mounted on
head, remove the DLC from
the Helmet. Dispose the DLC
according to your institution’s
protocol for contaminated waste.
2. Loosen the rear Headband Adjustment
Knob by turning it counterclockwise
3. Hold the front top of the Helmet in
one hand and with the other hand on
the Adjustment Knob; lift the Helmet
up and off the head.
5. Disconnect the Battery Belt from
around the waist by un-snapping the
buckle.
6. With the Charger connected
to the mains wall power,
connect the Charger Cord to
the Battery. Push the Charger
Cord Connector into the Battery
Receptacle until it is fully seated.
7. The entire CAPR System may be
decontaminated, cleaned and/or stored
at this time.
4. Disconnect the Helmet Power
Cord from the Battery - push
the Secure Connection Button
down, pull Cord Connector out,
release the Button.
8. If desired, all components of the CAPR System may be dis-
assembled and each component decontaminated, cleaned
and/or stored at this time.
To Next Page
Loading...