Page 80 P/N 03521015 Rev K
23.Continue pulling Hood inside-out
up and over Hood and HLF to
ensure contaminated outside is
folded up inside.
24. Continue pulling Hood off front
of Helmet releasing the Lens
from its Helmet attachment
points.
21. Untie both Neck and
Body Ties.
Either retie Neck ties
very loosely or cut them
off Hood to ensure Neck
Ties do not contaminate
Helmet, gown, or wearer.
Doff:
25. Discard Hood and HLF
per institutional protocol for
contaminated waste.
22.Grasp both Body Ties
and pull up to bring
back bottom of Hood
up and over Helmet.
26. Doff and
discard gown
per gown
supplier
protocol.
20. Ensure Hood Skirt is fully down on
all sides. Secure Neck ties to within
about 1/2 inch of neck. Secure body
ties around waist area.
18. Initiate donning of Heavy Loading
Filter (HLF) by tucking back bottom
up under back bottom of Helmet
19. Complete donning of HLF by pull-
ing down rear-to-front and securing
front bottom on Hood front velcro
strips (both sides in front).
29. Disconnect the Helmet
Power Cord from the
Battery - push the Se-
cure Connection Button
down, pull Cord Con-
nector out, release the
Button.
28. Lift Helmet up and off
Head
27. Loosen Headband
by turning Ratchet
Know fully counter-
clockwise.
To Next Page
Loading...