MAXA i-32V5C MIDI 0121 - Analogue Input Set-point Modification; Circulator Modes and Compressor Logic

12
P1
P2
P3 P4
A
B
Xa
Yb
Model i-32V5C
Midi




  X
a
 Y


 215 205 1600 680 1060 310
 225 215 1600 680 1060 320
The posions provided for the installaon of vibraon dampers for each type of machine are shown in the pictures below.
P1 P2
P3 P4
333
313
960
TECHNICAL SERVICE AREAS
All models in the series are designed and constructed for outdoor installaon.
It is good pracce to create a support slab of adequate size for the unit. The units transmit a low level of vibraon to the ground: it is never-
theless advisable to place an-vibraon mounts between the base frame and the support surface.
SUSPENDED INSTALLATION IS PROHIBITED



