MAXA i-32V5C MIDI 0121 - Parameters, Tables, and Alarms; Operating Bands and Offset Management

i-32V5C MIDI Inverter Air/Water chillers with axial fan
21
0
10
20
30
40
50
60
70
80
90
0 0,2 0,4 0,6 0,8 1 1,2 1,4 1,6 1,8 2 2,2 2,4 2,6
p [kPa]
ṁ [m
3
/h]
i-32V5C Midi 0126
p ToutDS=45°C ToutDS=55°C
0
10
20
30
40
50
60
70
80
90
0 0,2 0,4 0,6 0,8 1 1,2 1,4 1,6 1,8 2 2,2 2,4 2,6
p [kPa]
ṁ [m
3
/h]
i-32V5C Midi 0132
p ToutDS=45°C ToutDS=55°C
 
/h] 
UNIT AND AUXILIARY ELECTRICAL DATA
  
  12/1/50
  12/1/50
  
-
tached to the unit.
6. CORRECTIVE FACTORS

The correcon factors for water ow rate and pressure drop must be applied to the values obtained without the use of glycol. The correcon
factor for water ow rate shall be calculated to maintain the same temperature dierence as would be obtained without the use of glycol. The
pressure drop correcon factor is applied to the water ow rate value corrected by the water ow rate correcon factor.
  
Power input correc-

-

Pressure drop correc-

   1  
     
     
     
     
SCALING CORRECTION FACTORS
The correcon factors due to contaminaon of the internal gas/water exchanger are shown below.
  
  
  
  
CALIBRATIONS AND PROTECTIONS CONTROLS
 Value
 
 
 