MAXA i-32V5C MIDI 0121 - Description of Accessories; Factory-Fitted Standard Components

8
 Accessory Standard Factory installed
Supplied loose/

delivery
 x x
 x x
 x x
 x x
 x x
 x x
 x x
 x x
 x x
 x x
 x x
 x x
 x x
 x x



x x
 x x


x x
 x x
 x x
 x x
 x x
 x x
 x x
 x x
 x x
 x x
DESCRIPTION OF ACCESSORIES

Electronic expansion valve
expansion valve, designed for the control and connuous regulaon of the amount of refrigerant fed into the evaporator. Changes in thermal
load may be followed quickly, so as to achieve opmised consumpon.
Electronic circulator
standard on the unit, electronically controlled and high eciency.
Water-side safety valve
Valve installed on the hydraulic circuit to control overpressure - seng 6 bar

Device whose task is to control and signal the circulaon of water in the plate heat exchanger. This component is of fundamental importance
because it shuts down the unit and makes it safe by prevenng the formaon of ice.

contact on the terminal board that allows the unit to be switched on and o.
Dynamic set-point
the regulator allows the set-point to be modied by adding a value according to the temperature of the external air probe.

signals the presence of all three phases in the correct sequence.